Modifica espansione di banda per KENWOOD TH-27A

[RADIOMOD]

KENWOOD TH-27A

EXPANDED RF


1 - Disconnect the power and antenna.

2 - Remove 4 screws from the back panel.

3 - Open the bottom of the front panel first and slide the panel downward.

4 - Open the radio being careful not to break the flex cable.

5 - Move the tone board out of the way to expose the green jumper wire
located inside the front panel assembly.

6 - Cut the GREEN jumper wire.

7 - Remove chip resistor R337 ( Disables AM receive & audio offset ).

8 - Reassemble the radio. Carefully re-seat the O-ring on the BNC connector.

9 - Reset the microprocessor. Press and hold [M] key and turn the power on).