Modifica espansione di banda per KENWOOD TH-45A

[RADIOMOD]

KENWOOD TH-45A
                   
EXPANDED RF


1- DISCONNECT POWER AND ANTENNA.
2- Remove the volume. squelch and tuning control knobs.
3- Remove the nuts from the volume control and tuning controls
4- Remove the screws located by the PTT switch.
5- Remove the screws by the speaker jack.
6- Remove the screws from the battery plate.
7- Carefully pull the front panel from the radio. Do not break any wires.
8- Gently lift the top panel from the radio by pulling it forward and then
Upwards. The O ring on the BNC connector will cause same tension.
9- Rotate the top the panel towards the front of the radio to expose the
.75" x .75" board.
10- Remove chip resistor R-18 and R-28.
11- Reset the radio