Modifica espansione di banda per ICOM IC-W2A

[RADIOMOD]

                              ICOM  IC-X2A
                     
                             EXPANDED   RF


Modification Instructions for the IC-W2A Handheld
Two mods, one for Cross Band Repeat and one for extended TX range

1- Remove battery and antenna.
2- Remove screws from back panel and battery plate and open radio.
3- Remove PLL deck and power plate.
4- Unplug VHF & UHF decks.
5- Remove chip diode D22.
6- ATTACH chip diode to location points  A & B.
    ( diode MA133 - ICOM part # 1790000860 ).
7- Reassemble the radio.
8- RESET the CPU ( Push and hold [ FUNCTION ] & A & CLR and turn power ON).


     RX Expansion   Push and hold # & B & 3 and turn power ON.
     Direct Entry   Set VFO PL to 100Hz on VHF and UHF !!!
                    [F] & [SET] to select 1, 10, OR 100 Mhz freq. entry.

     Xband Repeater ON   Hold [FUNCTION] press [2] and them #
     Xband Repeater OFF  Push and hold [FUNCTION] & #
     Xband Text          Push and hold # & [light] & #