Modifica espansione di banda per KENWOOD TH-26A

[RADIOMOD]

KENWOOD TH-26A

Expanded RF Alignment controls


1 - Disconnect the power and antenna.

2 - Remove 3 screws from the case and 2 from the battery panel.

3 - Open the radio.

4 - REMOVE JUMPER JP1. Use a soldering iron the remove the jumper.
Do not pull the jumper or overheat the board.

5 - Unsolder and remove chip resistor R56.

6 - Reassemble the radio. Carefully re-seat the O-ring on BNC connector.

7 - Reset the microprocessor. ( Press and hold the [ F ] key and turn
the radio ON ).

NOTE: Automatic offset selection will be disabled when this mod is performed.